![]() Each of the resistors should have 453 Ohms resistance. Check the resistance of the three MCOR wires that are connected MCOR 3 pin plug to controller 16-pin plug. There is a failed resistor in the converter harness box.Identify the correct diode and do a replacement. On an Excel Club Car, one or more diodes in the wire harness aren’t functioning.This fault also specifies that the pedal limit switch has failed to close. The High Pedal Detect (HPD) fault is identified if the accelerator is depressed already when the key switch of the cart is put to ON position.Ī fault can also occur if the accelerator is pressed when the preferred direction is altered with a press of the Forward/Reverse switch. The IQDM controller response code for HPD is A. The following table gives a list of controller related faults identified by the IQ System Display Module (IQDM) handheld programming and diagnostic tool and their corresponding controller responses for a Club Car IQ System golf cart. The following table gives a list of fault codes used in troubleshooting a Club Car Precedent along with what they represent and the causes for the faults.Ĭontroller temperature is above normal or standard.Įxternal supply outside specified range limitĬart in both forward and reverse select at a timeĬontroller Faults for a Club Car IQ System The User Programmer has the least number of functions. The Dealer Programmer is equipped with more functions than the Service Programmer and the User Programmer. The Curtis 1313-4401 programmer is the most pricy OEM Programmer version and has a greater number of functions than other versions.Ĭurtis 1313-3301, Curtis 1313-2201 and Curtis 1313-1101 are the Dealer Programmer, Service Programmer and User Programmer versions respectively. You can also use an appropriate Curtis 1313 programmer to diagnose or program any IQ Club Car. ![]() The IQ System Display Module (IQDM) is a handheld diagnostic tool that is specifically intended for Club Cars. The user version has the maximum number of functions while the functions in the manufacturer version are limited. On average, the tool costs around USD 650. They are the user, technician, dealer and manufacturer versions.
0 Comments
Leave a Reply. |